Wall or Vanity Mounting Instructions

Select a mounting location before installing the unit. 

Important Considerations:
The dispenser door uses a partial sliding dovetail to allow the unit to open for refilling. The door needs ¾ of an inch (18mm) clearance dispenser to refill the unit. Ensure there is enough clearance to slide the door fully off and on. 

Also, when installing the door, the tabs on the door must align with the slots on the wipe dispenser body before sliding the door on. When fully seated, the door will click in place. Note: Earth Rated models do not do this. 

Mounting the Unit

1. Hold the unit in the desired position and use it as a template.
   Mark the mounting holes with a pencil through the wipe opening, then set the unit aside.
   
   
2. Prepare the mounting surface:
   Drywall:
   Use the included drywall anchors. Drill two 3/16-inch holes for the anchors.
   Wood or solid surfaces:
   Use the included screws directly. Pilot holes may be required for hardwood.
   
   
3. Reposition the unit, align it with the holes, and install the screws until secure.
   Installation is complete.
   
   
4. Visit our How it Works page for wipe loading and operating instructions to see why Lid-Lock is a game changer for your wipe experience.